A carbon fiber tiller extension built to fit the new Tohatsu 2020+ 25-90HP multifunction outboard motors. The tiller for this model has a Tilt and Trim switch on the end of the grip. Easy to install and remove. You do not have to modify the motor for installation. A remote switch for tilt and trim (if applicable) or jack-plate is available. We drill a 1 1/4" hole into the top of the TillerPillar to allow for access to the factory tilt switch.
The listed length is for the overall length of the TillerPillar, including the area that slides over your existing grip. Measure from the rear most portion of the rubber part of the handle; not including the 1" hard plastic piece with the triangular throttle indicator.
IMPORTANT: Please verify the rubber grip on your motor matches the rubber grip in the first picture on this page. If you have any questions as to which TillerPillar model you should order, please send an email to sales@carbonmarine.com with a picture of your rubber grip and we would be more than happy to assist you.